Skip to content

SA Filament Bed Adhesive - 200ml

Original price R 75.00 - Original price R 75.00
Original price
R 75.00
R 75.00 - R 75.00
Current price R 75.00

Only 24 in stock.

Add to Wishlist

Bed adhesive for use with PLA and PETG on heated beds.

  • Minimal smell
  • Strong hold from large prints or small contacts on bed
  • Easy removal of prints after the bed has cooled down

Customer Reviews

Based on 3 reviews
0%
(0)
33%
(1)
0%
(0)
33%
(1)
33%
(1)
V
Vincent van der Merwe
Correct my previous rating

So this does not work well with normal glass it never sticks however it sticks extremely well on tempered glass and gives a beautiful bottom layer gloss finish

V
Vincent van der Merwe
Does not work

It does not work print layers just slide accross the glass with the nozzle. Pritt still works the best so far on glass

R
Robert Venter
Standard Bed Adhesive

I have a test print that consist of multiple little items and it covers 80% of the print bed and is a 3 and a Half hour print.
My 1st try with this adhesive failed when the print started to lift when the print was 73% completed. ( I used the settings I normally used
when I use Fiesta) I did a second trial with the print bed temperature 5 degrees more and this one failed at 90%.
I then used Fiesta Extreme and lower the print bed temperature back to the 1st trial which is my standard I print with and I print a perfect print.
I would therefore stay with Fiesta and not use this bed adhesive.

Customer Reviews

Based on 3 reviews
0%
(0)
33%
(1)
0%
(0)
33%
(1)
33%
(1)
V
Vincent van der Merwe
Correct my previous rating

So this does not work well with normal glass it never sticks however it sticks extremely well on tempered glass and gives a beautiful bottom layer gloss finish

V
Vincent van der Merwe
Does not work

It does not work print layers just slide accross the glass with the nozzle. Pritt still works the best so far on glass

R
Robert Venter
Standard Bed Adhesive

I have a test print that consist of multiple little items and it covers 80% of the print bed and is a 3 and a Half hour print.
My 1st try with this adhesive failed when the print started to lift when the print was 73% completed. ( I used the settings I normally used
when I use Fiesta) I did a second trial with the print bed temperature 5 degrees more and this one failed at 90%.
I then used Fiesta Extreme and lower the print bed temperature back to the 1st trial which is my standard I print with and I print a perfect print.
I would therefore stay with Fiesta and not use this bed adhesive.