Skip to content
*Free shipping for orders over R1000 only to major cities (T&C's apply)
*Free shipping for orders over R1000 only to major cities (T&C's apply)

All metal heat break 1.75mm

Original price R 45.00 - Original price R 45.00
Original price R 45.00
R 45.00
R 45.00 - R 45.00
Current price R 45.00

Only 11 in stock.

Add to Wishlist
All metal heat breaks are advised when printing with filament that requires higher printing temperatures such as PETG.

Customer Reviews

Based on 2 reviews
0%
(0)
0%
(0)
50%
(1)
0%
(0)
50%
(1)
F
F.J.
Decent product

Works for the higher temp filaments however does require some finishing if you want it to perform better. There's a few guides online for polishing..

S
Sevineshan
Terrible product

Very very unhappy with this heat break. Firstly, it didn't want to fit into the heat sink - had to shave off a little bit from the outside of the heat break. Then I found that the filament wasn't going through the heat break because the hole was too small at the end. Absolutely frustrated with this heat break

Customer Reviews

Based on 2 reviews
0%
(0)
0%
(0)
50%
(1)
0%
(0)
50%
(1)
F
F.J.
Decent product

Works for the higher temp filaments however does require some finishing if you want it to perform better. There's a few guides online for polishing..

S
Sevineshan
Terrible product

Very very unhappy with this heat break. Firstly, it didn't want to fit into the heat sink - had to shave off a little bit from the outside of the heat break. Then I found that the filament wasn't going through the heat break because the hole was too small at the end. Absolutely frustrated with this heat break

Net Orders Checkout

Item Price Qty Total
Subtotal R 0.00
Shipping
Total

Shipping Address

Shipping Methods