Skip to content

3D Touch

Sold out
Original price R 499.00 - Original price R 499.00
Original price
R 499.00
R 499.00 - R 499.00
Current price R 499.00

Only 0 in stock.

-This is an auto leveling sensor for 3D Printers based on open-source.
-Simple, Smart, High-precision
, It could work with any kinds of bed materials, such as glasses, woods, metals, and so on.
-It can be operated in the following conditions:

-One I/O for control (PWM or Software PWM)
-One I/O for Zmin(Z Probe)
-GND and +5V  power


Notes:

-Additional power supply can be needed if your board does not supply enough amperage.
-Electronic devices can be damaged or even destroyed if connected to the wrong side polarity.    [wrong terminal connect to 5V(+) and GND(-)]
-Install BLTouch as far as it possible from magnetic, motor, fan etc.
-The action as pulling/pushing hard the push-pin can make the BLTouch damaged and less accurate.
-Fix push-pin with locking paint after reassembling or adjusting core.
-Please do not change the position of the hexagon screw(core).
-Do not separate or deform elastic material attached on the push-pin.
-The action(Pull or push push-pin hard) makes damage and lowers the accuracy of sensor



Customer Reviews

Based on 2 reviews
50%
(1)
50%
(1)
0%
(0)
0%
(0)
0%
(0)
J
Jacques Fourie
3D touch test and install

It works well without any issues. Good product for the price.
Make sure you know exactly what to do before installing this device or you will be pulling out your hair.
Research is key.

s
sl0m0
3D Touch works well

The only catch with this device is that you MUST download the online instructions.
Mounting height is critical - 1mm too high or too low and you will struggle.
Print yourself an adjustable mount for it - uses same mount as the BLTouch.
Fine tune your Z-Axis offset.
Works well once set up.

Customer Reviews

Based on 2 reviews
50%
(1)
50%
(1)
0%
(0)
0%
(0)
0%
(0)
J
Jacques Fourie
3D touch test and install

It works well without any issues. Good product for the price.
Make sure you know exactly what to do before installing this device or you will be pulling out your hair.
Research is key.

s
sl0m0
3D Touch works well

The only catch with this device is that you MUST download the online instructions.
Mounting height is critical - 1mm too high or too low and you will struggle.
Print yourself an adjustable mount for it - uses same mount as the BLTouch.
Fine tune your Z-Axis offset.
Works well once set up.